This episode starts with a quick chat about solar batteries because Stefan was faced with a power outage on the morning of the recording. After that Tom and Stefan switch over to a discussion about new ways of 3D scanning and AI image and video generation. Then they talk about Bambulabs’ next budget printer, the P1P, and also touch on why there might not be a ton of coverage on Ankers Ankermake M5. Next, there is a quick discussion on the 3D Printing Industry Award and how they recently nuked themselves with very questionable behavior. After that, Stefan shares his impressions on Formnext 2022, and they discuss an incident where Creality used they open-style laser engraver on the event without any safety precautions. Finally, Tom presents his new coffee equipment, and Stefan answers a question about his plywood CNC router.

Drop your questions for upcoming episodes in the comments below or tweet them @TheMeltzone (https://twitter.com/TheMeltzone).

Subscribe to the main channels
Thomas Sanladerer: https://www.youtube.com/user/ThomasSanladerer?sub_confirmation=1
Stefan (CNC Kitchen): https://www.youtube.com/channel/UCiczXOhGpvoQGhOL16EZiTg?sub_confirmation=1

Support us on Patreon
Tom: https://www.patreon.com/toms3dp
Stefan: https://www.patreon.com/cnckitchen

Intro Jingle by Thomas Herrmann: https://raise-uav.com

Recording date: 2022/11/21

### SHOW NOTES ###

Corridor Crew – NERF: https://www.youtube.com/watch?v=YX5AoaWrowY
Bambulab P1P: https://youtu.be/JOzAMTbb0Fs
3DPI nuking themselves: https://twitter.com/joeltelling/status/1593558038455148546?t=TfdQk4IncmKeECwPhnRCFg&s=19
Creality Incident: https://twitter.com/moorviper/status/1592921116703870978?s=20&t=HS-s7GkBNjouu95EVXzD7g
Espresso Maker – Gaggia New Classic (aff): https://geni.us/UZ3DN
Espresso Grinder – Eureka Mignon (aff): https://geni.us/9zUmnB